Skip to content

BCH8 support for OMAP3

Andreas Bießmann u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 4 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 4 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [RFC/PATCH 0/4] BCH8 support for OMAP3
Quoted 4 lines · Andreas Bie?mann

This RFC series implements BCH8 for OMAP3 as provided by linux kernel in commit 0e618ef0a6a33cf7ef96c2c824402088dd8ef48c.
This series is heavily influenced by Ilyas series 'NAND support for AM33XX' thus could share some code.

Any comments on that series? I would appreciate to get the BCH8 support in for at least the tricorder board.

Quoted 2 lines

I have managed to load kernel from an ubifs written by the kernel driver, but is far away from tested thoroughly.

We used that patchset for a while in-house and could not find obvious issues. However we need to hack the SPL a bit to get the bigger footprint into SRAM with 2013.01.
I would really appreciate if some other omap users could test it. One thing is that most current NAND (even SLC) devices require at least 4Bit ecc for most sections.

Quoted 4 lines

Cause my NAND device 'NAND device: Manufacturer ID: 0x2c, Chip ID: 0xbc (Micron NAND 512MiB 1,8V 16-bit)' does support 1bit ECC for first sector if erase is less than 1000, the rest requires 4bit ECC. Therefore the SPL needs to support BCH, the impact is about 9k for the SPL.

So my question here is if this series would be accepted for the upcoming release. I could work on it next week full time, so if I get a go for this release I would do so.

Best regards

Andreas Bie?mann