Skip to content

RFC: Port Virtex-II Pro code to use the platform bus

Grant Likely linuxppc-dev 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 8 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2Move Virtex-II Pro / ML300 port over to the platform bus.arch/ppc/Kconfig.debug arch/ppc/boot/common/ns16550.= arch/ppc/boot/common/ns16550.c +16 more+37 -204 replies
2/2Add support for MEMEC 2VP30-FF1152 eval board with simple FPGA designarch/ppc/boot/simple/embed_config.c arch/ppc/platforms/4xx/Kconfi= arch/ppc/platforms/4xx/Kconfig +8 more+130 -03 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] RFC: Port Virtex-II Pro code to use the platform bus

Here is my work to date to bring the V2Pro port over to the platform bus. I don't expect these to be accepted as-is, but I'm looking for comments before I get it polished.

Should apply cleanly against 2.6.13 (but may require the TLB patch first)
http://patchwork.ozlabs.org/linuxppc/patch?id=3D2058

Patch 1: changes from the ML300 perspective. I temporarly don't have access to an ML300 so this is untested (but it compiles). Could somebody please test this for me?

Patch 2: example patch for another V2PRO based board. This isn't really acceptable for mainline because it's not based on a reference or published FPGA design, but it shows the work required to bring up another board. It also shines some light on what code should be common between all V2Pro ports (which I'm working on). This one runs on a 2VP4-FG456 eval board (pls ignore all the references to 2VP30).