ARM: sa1100: Rework IRQ handling
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest0 of 9 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 9 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/9] ARM: sa1100: Rework IRQ handling
Quoted 15 lines · Linus Walleij
Quoted 6 lines · Dmitry Eremin-Solenikov
Quoted 1 line · Linus Walleij
And that happens before the GPIO driver gets registered -> crash.
That is not the issue. The real issue is h3xxx using those gpio's without previously calling
gpio_request.Really? But that wasn't done before this patch either.
It is basically OK to use the gpio_* functions before or without requesting the GPIOs, it won't look nice but it works.
Quoted 7 lines
Quoted 3 lines
Unfortunately sa1100 driver doesn't have a
good place to request gpios. When faced this problem during locomo refactoring, I ended up with the following piece of code:(...)
Quoted 1 line
Russell, Linus, what do you think about the previous solution?
That looks OK but is that really the problem?
I have reworked h3xxx GPIO handling to (hopefully) not to cause the problem. I have sent the patches yesterday.
Linus, Could you please check if both series work (and make sense to you)?
Signature · 2 lines
With best wishes Dmitry