Add support for TQMa6 modules
Get series with b4
b4 am [email protected]Versions newest first
- v2 Latest0 of 7 patches 0 repliesNew
Patches in v2 No applies recorded yet
None of the 7 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.
Cover letter [U-Boot] [Patch v2 0/7] Add support for TQMa6 modules
Hello Stefano,
Am 17.06.2014 19:58, schrieb Stefano Babic:
Quoted 4 lines
Hi Markus,
On 17/06/2014 19:40, Markus Niebel wrote:
Quoted 9 lines
Quoted 5 lines
Quoted 3 lines
Is it not an attractive alternative for you ? Instead of having several entries in boards.cfg for each variation of your board, you could have maybe only one or a couple.
Sure it is - main difference will be boot devices.
Right - I am expecting then an entry in boards.cfg for each media, that is able to run on all SOCs.
Do you mean, accepting the board needs the switch to SPL / single image support? Or will the current solution - one entry for TQMa6 with MX6Q/D and one for TQMa6 with i.MX6S - be accepted?
Quoted 11 lines
Quoted 3 lines
The env on different boot media
in one image is AFAIK not possible - so at the moment four configs are needed:
SP vs MMC and i.MX6Q/D vs i.MX6S (But this is slightly OT)Well, SP vs MMC is right. But having an entry for all SOCs without having to select one of it at compile time, it is really a plus ;-)
Best regards,
Stefano Babic
Best Regards
Markus