Allow to use leds-ns2 with n090401 boards
Get series with b4
b4 am [email protected]Versions newest first
- v2 Latest0 of 4 patches 0 repliesNew
Patches in v2 No applies recorded yet
None of the 4 patches the cover letter announces are in this archive.
Reviews trailers per patch
| Patch | Jacek Anaszewski |
|---|---|
| Series | A-b |
Trailers given in replies are filled; those carried in the patches from earlier versions are outlined with dashes.
Cover letter [PATCH v2 0/4] Allow to use leds-ns2 with n090401 boards
Hi Simon,
Quoted 38 lines · Simon Guinot
Hello,
This patch series allows to use the leds-ns2 driver with the n090401 boards (Seagate NAS 4-Bay), based on an Armada-370 SoC.
Here is the list changes:
- Allow to configure the LED mode mapping.
- Handlecan_sleepGPIOs. On n090401, the LEDs are connected to an I2C GPIO expander.
- Make leds-ns2 depends onMACH_ARMADA_370.Changes for v2:
- Fix gpio_{get,set}_*_cansleep() usage while holding a spinlock:
Holding a spinlock at this places was not needed.
- Add Acked-by from Jacek Anaszewski for patch 4.Simon
Simon Guinot (2):
leds: leds-ns2: handlecan_sleepGPIOs
leds: leds-ns2: depends onMACH_ARMADA_370Vincent Donnefort (2):
leds: leds-ns2: move LED modes mapping outside of the driver
ARM: Kirkwood: add modes-map property to ns2-leds nodes.../devicetree/bindings/leds/leds-ns2.txt | 9 ++ arch/arm/boot/dts/kirkwood-d2net.dts | 5 + arch/arm/boot/dts/kirkwood-is2.dts | 5 + arch/arm/boot/dts/kirkwood-ns2.dts | 5 + arch/arm/boot/dts/kirkwood-ns2max.dts | 5 + arch/arm/boot/dts/kirkwood-ns2mini.dts | 5 + drivers/leds/Kconfig | 12 +- drivers/leds/leds-ns2.c | 169 ++++++++++++--------- include/dt-bindings/leds/leds-ns2.h | 8 + include/linux/platform_data/leds-kirkwood-ns2.h | 14 ++ 10 files changed, 165 insertions(+), 72 deletions(-)
Quoted 2 lines
create mode 100644
include/dt-bindings/leds/leds-ns2.h
For the whole patch set:
Signature · 2 lines
Best Regards, Jacek Anaszewski