clk: lpc32xx: add clock support for NXP LPC32xx
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest0 of 11 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 11 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx
Hi Sylvain,
Quoted 5 lines · Sylvain Lemieux
Quoted 3 lines · Vladimir Zapolskiy
This changeset adds common clock framework driver for NXP LPC32xx boards.
Quoted 7 lines
Hi Vladimir,
Just to let you know that we did some testing using this changeset; I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1.
I was able to run our software (SIC1 interrupt sources disable) without any problem a custom LPC32xx board.
this is a known issue, and I hope it will be fixed in upstream in v4.6, the required changes in irqchip and gpiochip drivers were sent for review some time ago, a bit more work is needed to
Also 2-3 more clean-up changes in USB host and gadget drivers are done locally (no more need to configure clocks out of the common clock framework), but not yet submitted, will do it tomorrow.
Quoted 2 lines
We did not get any problem with the clock signals we are using.
Thank you for testing, I'm going to add your Tested-by tag (if you don't mind) and submit a PR to ARM maintainers shortly.
Quoted 5 lines
Quoted 5 lines
Vladimir Zapolskiy (11):
dt-bindings: clock: add description of LPC32xx clock controller
dt-bindings: clock: add description of LPC32xx USB clock controller
dt-bindings: clock: add NXP LPC32xx clock list for consumers
arm: dts: lpc32xx: add device nodes for external oscillators
Quoted 10 lines
Quoted 8 lines
arm: dts: lpc32xx: add clock controller device node
arm: dts: lpc32xx: add clock properties to device nodes
arm: dts: lpc32xx: add USB clock controller
clk: lpc18xx: add NXP specific common clock framework selection
clk: lpc32xx: add common clock framework driver
arm: lpc32xx: switch to common clock framework
arm: dts: lpc32xx: remove clock frequency property from UART device
nodes
With best wishes,
Vladimir