Add support for Amlogic Meson MMC controller

Quoted 10 lines · Robert Gadsdon

Quoted 9 lines · Carlo Caione

Quoted 3 lines · Carlo Caione

Quoted 2 lines · Robert Gadsdon

Applied this on my Odroid C2, and it worked OK when installed on the SDcard, but failed when installed on the eMMC module:

Oh, reading this again you meant that you put u-boot directly on the eMMC? Ok then, something is wrong when using the driver with the eMMC.

Yes, I installed it directly on the eMMC, using the micro-sd adapter, and following the same instructions as for the SDcard..

Could you try with this patch?

board/hardkernel/odroid-c2/odroid-c2.c +0 -0

index 34b9a95..ab78328 100644
@@ -80,6 +80,11 @@ U_BOOT_DEVICE(meson_mmc) = {
        .platdata = &gxbb_sd_platdata[CONFIG_MMC_MESON_SD_PORT],
 	 };
 
 	  +U_BOOT_DEVICE(meson_emmc) = {
 	  +       .name = "meson_mmc",
 	  +       .platdata = &gxbb_sd_platdata[2],

	  +};
	  +
	   static void meson_mmc_pinmux_setup(unsigned int port)
	    {
	            switch (port) {

Thanks,