Skip to content

mx7: add dt support for Colibri iMX7S/iMX7D

Stefano Babic u-boot 3 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v3 Latest posting 2/20 of 10 patches 0 repliesNew
  2. v3 posting 1/21 patch 0 repliesSuperseded
  3. v24 of 9 patches 0 repliesSuperseded

Patches in v3 posting 2/2 No applies recorded yet

None of the 10 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [U-Boot] [PATCH v3 00/10] mx7: add dt support for Colibri iMX7S/iMX7D
Quoted 12 lines · Stefan Agner

From: Stefan Agner <[email protected]>

This patchset adds device tree support for Colibri iMX7S/iMX7D. It is the first device tree enabled board for any i.MX 7 SoC hence the patchset adds some common infrastructure:
- Add device tree support for serial_mxc.
- imx7.dtsi - I descided to leave the s/d suffix since the SoCs are very similar and boards will likely use runtime detection to distinguish the two available SoCs.
- The pinmux file imx7d-pinfunc.h is taken from the Kernel and stored in the same place

Quoted 9 lines

Otherwise the conversion is quite straightforward and simplified the board code somewhat. Two patches enhance the board support with PMIC support, which has been the driver for this conversion.

Changes since v2:
- Drop CONFIG_CUSTOM_BOARDINFO again
- Add ifdef OF_CONTROL in serial-mxc driver to allow building the driver without OF support

Thanks - I merge the whole series and push to -master.

Regards,
Stefano

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================

Read the cover letter in its thread