Skip to content

SD/MMC driver for MX25/35/51

Arnaud Patard (Rtp) linux-arm-kernel linux-mmc 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 6 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 6 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/6] SD/MMC driver for MX25/35/51

Wolfram Sang <[email protected]> writes:

Hi,

Quoted 8 lines · Arnaud Patard
Quoted 7 lines
Quoted 6 lines
Quoted 4 lines

it's actually not yet supported by the driver. There is a wp_gpio in struct esdhc_platform_data (arch/arm/plat-mxc/include/mach/esdhc.h) but it's not yet used by the driver.

It's all prepared. I finally will have a look into it today.

Quoted 7 lines
Quoted 3 lines

oh, great. I was thinking about doing it but I'll wait for your patches then. I'm sure I need support for WP on GPIO but I may also need support for CD on GPIO so I'll be happy to test any patch you have.

Just to keep you updated: Got a bit distracted again but I hope to finish it on Saturday. Looks like a patch for the gpiolib is also needed...

ok. Take your time. It turns out that the infos I had were a bit misleading. I've been told the mmc driver was using some gpios and the gpios are GPIO_1_0/1_1 and GPIO_1_7/1_8... which are in fact the esdhc1 and esdhc2 CD and WP.

This means :
- with proper iomux configuration, WP detection is working fine
- I should still be able to test WP on GPIO

Thanks,
Arnaud