Skip to content

MX31: NAND boot for PDK boards.

Magnus Lilja u-boot 6 versions – New

Get series with b4
b4 am [email protected]

Versions newest first · linked by author and title

  1. v4 Latest posting 3/30 of 6 patches 0 repliesNew
  2. v4 posting 2/30 of 6 patches 0 repliesSuperseded
  3. v4 posting 1/36 patches 0 repliesSuperseded
Earlier versions · 3
VersionPostedPatchesRepliesStatus
v36 patches0 repliesSuperseded
v23 patches0 repliesSuperseded
v1 RFC5 patches0 repliesSuperseded

Patches in v4 posting 3/3 No applies recorded yet

None of the 6 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v4 yet.

Read the v4 thread

Cover letter [U-Boot] [PATCH v4 0/6] MX31: NAND boot for PDK boards.

Hi

2009/6/19 Ulrich Gerster <[email protected]>:

Quoted 11 lines

Hi everybody
and especially developers of i.MX31 NAND boot patches,

I wrote an e-mail yesterday asking about the need of the mx31_nand.c file in drivers/mtd/nand/ folder. Since nobody answerd I tried to review the development of the latest patch "[PATCH v4 0/6] MX31: NAND boot for PDK boards." historically. It's probably a stupid question but for me as a u-boot newbe it would be very helpful.

I started in August 2008 where I found the first patch called "[PATCH RFC 0/5] Add NAND Support..." and later two patches with the same title and the prefix [PATCH v2 0/6] and [PATCH v3 0/6] from Magnus Lilja. In October Mr. Assis posted a patch regarding to this topic aswell.
In December and January Maxim Artamonov postet a patches to introduce NAND SPL support.
In April then another series of patches from Magnus Lilja were posted with the title "[RFC 0/5] MX31: NAND boot for phyCORE and PDK boards." I think based on this in April version 2 and and in June now version 3 and 4 were posted by Magnus Lilja.

As I can see the latest patch includes all the necessary code from the previous patches. So no other patch has to be applied to boot u-boot from a NAND Flash on a board with the i.MX31 ?

That's correct.

Quoted 2 lines

But I had a very hard time doing this review and I'm not 100% sure if I'm correct
Would be very nice if someone could tell me if I'm right and if not tell me what I need more to boot from a NAND flash.

Booting U-Boot from NAND Flash on i.MX31 PDK requires nothing else. However, the current U-Boot does not have support to have the U-Boot environment or kernel in NAND since the mx31_nand.c driver is missing. There have been a number of patches containing such a driver but so far no one has been accepted.

Regards, Magnus