Skip to content

da850evm NAND support

Ben Gardiner u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 5 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 5 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [U-Boot] [PATCH 0/5] da850evm NAND support

This patch series adds NAND support to the da850evm. The support is in the spirit of that found in the omap-l1 and u-boot-davinci trees where NAND support can be enabled with the addition of a single '#define CONFIG_USE_NAND' to the top of the include/configs/da850evm.h file. Pinmux entries are added for NAND so that NAND is usable even when the boot mode is not from NAND. Also the mtdpart, ubi and ubifs commands are proposed to be added to the NAND support because of their importance when using NAND.

Ben Gardiner (5):
davinci_nand, trivial : use symbolic ECC start command da850evm : enable NAND even when not in NAND boot mode
da850evm: setup the NAND flash timings
da850evm: setup NAND support under CONFIG_USE_NAND
da850evm: add mtdpart and ubi commands with NAND support

 board/davinci/da8xxevm/da850evm.c |   40 +++++++++++++++++++++++++++++++++++++
 drivers/mtd/nand/davinci_nand.c   |    3 +-
 include/configs/da850evm.h        |   37 ++++++++++++++++++++++++++++++++++
 3 files changed, 79 insertions(+), 1 deletions(-)