Skip to content

ARM: kirkwood: Convert the mplcec4 board to pinctrl

Stefan Peter linux-arm-kernel 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 patch 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/1ARM: kirkwood: Convert mplcec4 board to pinctrlarch/arm/boot/dts/kirkwood-mplcec4.dts arch/arm/mach-kirkwood/board-mplcec4.c+64 -351 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/1] ARM: kirkwood: Convert the mplcec4 board to pinctrl

Hello Andrew

This is my try to convert the mplcec4 board to your pinctrl patches. The only problem I see is that I get an uart1 using mpp13 and mpp14 which are used by the mvsdio driver (and mentioned accordingly in the appropriate entry under /proc/device-tree/ocp at f00....). I did not find a way to get rid of this uart1 and because the SD card interface does work and no kernel errors or warnings are issued, it obviosely does no harm. However, I will rework this patch if you have some input in this respect.

Regards
Stefan Peter

Stefan Peter (1):
Convert mplcec4 board to pinctrl

 arch/arm/boot/dts/kirkwood-mplcec4.dts |   64 ++++++++++++++++++++++++++++++++
 arch/arm/mach-kirkwood/board-mplcec4.c |   35 -----------------
 2 files changed, 64 insertions(+), 35 deletions(-)
Signature · 1 line
1.7.9.5

Read the cover letter in its thread