RFC ARM: Machine specific boot blobs
Get series with b4
b4 am [email protected]Versions newest first
- v1 RFC Latest3 patches 3 repliesIn review
Patches in v1 No applies recorded yet
| # | Subject and files | Size | Replies | Applied |
|---|---|---|---|---|
| 1/3 | arm: boot: Add board specific setup code APIhw/ include/ | +18 | 0 replies | |
| 2/3 | arm: highbank: Implement dummy monitorhw/ | +45 | 0 replies | |
| 3/3 | arm: xilinx_zynq: Add linux pre-boothw/ | +40 | 0 replies |
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [Qemu-devel] [RFC 0/3] ARM: Machine specific boot blobs
Hi,
This adds support for machine specific primary boot blobs. This can be used to install little bits of firmware or boot code without having to throw the whole QEMU bootloader out and BYO (with device drivers and all).
It is then used to fix two boards, Zynq and Highbank, both which have small but critical expectations of pre-boot software setup.
Regards,
Peter
Peter Crosthwaite (3):
arm: boot: Add board specific setup code API
arm: highbank: Implement dummy monitor
arm: xilinx_zynq: Add linux pre-boot
hw/arm/boot.c | 11 +++++++++++ hw/arm/highbank.c | 56 +++++++++++++++++++++++++++++++++++++++++----------- hw/arm/xilinx_zynq.c | 41 +++++++++++++++++++++++++++++++++++++- include/hw/arm/arm.h | 7 +++++++ 4 files changed, 103 insertions(+), 12 deletions(-)
Signature · 1 line
1.9.1