Skip to content

unify drv_bss_info_changed between mt76x0u and mt76x2u

Lorenzo Bianconi linux-wireless 1 version Applied

Status from this message: Applied, thanks.

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest4 patches 1 replyApplied

Patches in v1 Applied

#Subject and filesSizeRepliesApplied
1/4mt76x2u: phy: add TX_SHAPING calibrationdrivers/net/wireless/mediatek/mt76/mt76x2/usb_phy.c+1 -00 replies
2/4mt76x2u: phy: run phy_channel_calibrate after channel switchdrivers/net/wireless/mediatek/mt76/mt76x2/mt76x2u.h drivers/net/wireless/mediatek/mt76/mt76x2/usb_main.c drivers/net/wireless/mediatek/mt76/mt76x2/usb_phy.c+15 -90 replies
3/4mt76x2u: main: use mt76x02_bss_info_changed utility routinedrivers/net/wireless/mediatek/mt76/mt76x2/usb_main.c+3 -200 replies
4/4mt76x2u: init: remove mt76x2u_init_beacon_offsets routinedrivers/net/wireless/mediatek/mt76/mt76x2/usb_init.c+0 -100 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/4] unify drv_bss_info_changed between mt76x0u and mt76x2u

Perform channel calibration after each channel switch and not only after connection establishment.
Enable MCU_CAL_TX_SHAPING phy calibration.
Moreover remove remove beacon offset configuration since the driver supports just client mode

Lorenzo Bianconi (4):
mt76x2u: phy: add TX_SHAPING calibration
mt76x2u: phy: run phy_channel_calibrate after channel switch
mt76x2u: main: use mt76x02_bss_info_changed utility routine
mt76x2u: init: remove mt76x2u_init_beacon_offsets routine

 .../wireless/mediatek/mt76/mt76x2/mt76x2u.h   |  1 -
 .../wireless/mediatek/mt76/mt76x2/usb_init.c  | 10 -------
 .../wireless/mediatek/mt76/mt76x2/usb_main.c  | 28 ++-----------------
 .../wireless/mediatek/mt76/mt76x2/usb_phy.c   | 19 +++++++++++--
 4 files changed, 19 insertions(+), 39 deletions(-)
Signature · 1 line
2.17.2

Read the cover letter in its thread