RFC PM / devfreq: Add imx driver
Get series with b4
b4 am [email protected]Versions newest first
- v2 RFC Latest0 of 3 patches 0 repliesNew
Changes since v2 from the cover letter
* Solve review comments
* Add yaml binding doc
* Add perf event support
Link to v2: https://patchwork.kernel.org/patch/11021571/
Patches in v2 No applies recorded yet
None of the 3 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v2 yet.
Cover letter [RFCv2 0/3] PM / devfreq: Add imx driver
This series attempts to add devfreq support for imx8mm, covering dynamic scaling of internal buses and dram.
Actual scaling is performed through the clk framework: The NOC and main NICs are driven by composite clks and a new 'imx8m-dram' clk is used for scaling dram using firmware calls.
Frequency target is set via "clk_set_min_rate", this allows an unrelated subsystem (for example interconnect) to also request minimum rates as a form for proactive scaling.
The dram controller (DDRC) has a performance monitoring block attached for which a perf driver already exists. Instead of reimplementing that as devfreq-events the perf in-kernel API is used.
Changes since v2:
* Solve review comments
* Add yaml binding doc
* Add perf event support
Link to v2: https://patchwork.kernel.org/patch/11021571/
DRAM frequency switching through clk framework is here:
* https://patchwork.kernel.org/patch/11049429/
That part might not be accepted in clk and it might have to be moved to devfreq also.
Leonard Crestez (3):
dt-bindings: devfreq: Add initial bindings for i.MX PM / devfreq: Add imx driver
PM / devfreq: Add imx perf event support
.../devicetree/bindings/devfreq/imx.yaml | 59 ++++ drivers/devfreq/Kconfig | 10 + drivers/devfreq/Makefile | 1 + drivers/devfreq/imx-devfreq.c | 278 ++++++++++++++++++ 4 files changed, 348 insertions(+) create mode 100644 Documentation/devicetree/bindings/devfreq/imx.yaml create mode 100644 drivers/devfreq/imx-devfreq.c
Signature · 1 line
2.17.1