Skip to content

arm64: zynqmp: Add support for running U-Boot in EL3 again

Michal Simek u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/3firmware: zynqmp: Enable IPI code calling also in EL3drivers/firmware/firmware-zynqmp.c+1 -10 replies
2/3arm64: zynqmp: Reorder parameters for zynqmp_mmio_write()board/xilinx/zynqmp/zynqmp.c+1 -10 replies
3/3arm64: zynqmp: Add support for u-boot.itb generation without ATFarch/arm/mach-zynqmp/mkimage_fit_atf.sh+12 -40 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/3] arm64: zynqmp: Add support for running U-Boot in EL3 again

Hi,

in past without PMU fw it was possible to run U-Boot in EL3. Firmware changes made ATF required that's why generation was done like this. But some recent changes (especially passing PMUFW object to PMU from SPL) introduce the whole infrastructure for talking to PMU via IPI interface. That's why this interface can be reused and run U-Boot in EL3 again.

Based on it I have fixed mkimage_fit_atf.sh script to generate u-boot.its/itb based on ATF availability but still producing working image without it.

Also found two issues which should be fixed to get U-Boot work in EL3.

Thanks,
Michal

Michal Simek (3):
firmware: zynqmp: Enable IPI code calling also in EL3
arm64: zynqmp: Reorder parameters for zynqmp_mmio_write()
arm64: zynqmp: Add support for u-boot.itb generation without ATF

 arch/arm/mach-zynqmp/mkimage_fit_atf.sh | 16 ++++++++++++----
 board/xilinx/zynqmp/zynqmp.c            |  2 +-
 drivers/firmware/firmware-zynqmp.c      |  2 +-
 3 files changed, 14 insertions(+), 6 deletions(-)
Signature · 1 line
2.25.1