Skip to content

x86/fpu: Allow clearcpuid= to clear several bits

John Haxby linux-doc lkml stable 1 version In review

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 patch 3 repliesIn review

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/1x86/fpu: Allow clearcpuid= to clear several bitsDocumentation/admin-guide/kernel-parameters.txt arch/x86/kernel/fpu/init.c+24 -183 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/1] x86/fpu: Allow clearcpuid= to clear several bits

Back in the mists of time, well, prior to 4.14.9, you could put clearcpuid=N several times on the command line to clear several CPUID bits. Unfortunately, there was a problem with the way that this was done which meant XSAVE, in particular, wasn't cleared early enough. This was fixed in 0c2a3913d6f5 ("x86/fpu: Parse clearcpuid= as early XSAVE argument"). Unfortunately that also meant that only one bit could be cleared.

This patch mostly fixes that. Gone is the old, anachronistic, multiple clearcpuid= arguments to be replaced by a single clearcpuid=BITNUM[,BITNUM,...] argument. It's no longer possible to clear perhaps dozens of flags with a very long kernel command line, but you can clear up to about eight bits now instead of just one.

jch

John Haxby (1):
x86/fpu: Allow clearcpuid= to clear several bits

 .../admin-guide/kernel-parameters.txt         | 24 ++++++++++---------
 arch/x86/kernel/fpu/init.c                    | 18 ++++++++------
 2 files changed, 24 insertions(+), 18 deletions(-)
Signature · 1 line
2.25.3