Skip to content

Add initial support for MikroTik RB3011

Jonathan McDowell linux-arm-kernel linux-arm-msm linux-devicetree lkml 1 version Applied

Status from this message: Applied, thanks!

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 2 repliesApplied

Patches in v1 Applied

#Subject and filesSizeRepliesApplied
1/3dt-bindings: vendor-prefixes: Add MikroTikDocumentation/devicetree/bindings/vendor-prefixes.yaml+2 -01 reply
2/3ARM: dts: qcom: add ethernet definitions to ipq8064arch/arm/boot/dts/qcom-ipq8064.dtsi+108 -00 replies
3/3ARM: dts: qcom: Add MikroTik RB3011arch/arm/boot/dts/Makefile arch/arm/boot/dts/qcom-ipq8064-rb3011.dts+309 -01 reply

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/3] Add initial support for MikroTik RB3011

This patches do some prep (device tree vendor addition, missing ethernet definitions for IPQ8064 dts) and then add an initial device tree for the MikroTik RB3011 1U router, which is an IPQ8064 device with 1G RAM. They are sufficient to boot with an initrd, the serial console and the first 5 switch ports fully functional (the second bank of 5 require some extra patches to the QCA8K driver which will follow later). The bootloader NOR is also supported, but the 128MB NAND is not yet enabled.

Jonathan McDowell (3):
dt-bindings: vendor-prefixes: Add MikroTik
ARM: dts: qcom: add ethernet definitions to ipq8064
ARM: dts: qcom: Add MikroTik RB3011

 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm/boot/dts/Makefile                    |   1 +
 arch/arm/boot/dts/qcom-ipq8064-rb3011.dts     | 308 ++++++++++++++++++
 arch/arm/boot/dts/qcom-ipq8064.dtsi           | 108 ++++++
 4 files changed, 419 insertions(+)
 create mode 100644 arch/arm/boot/dts/qcom-ipq8064-rb3011.dts
Signature · 1 line
2.20.1