Skip to content

Allow to specify the PHY number to use with a specific i.MX FEC/ENET Ethernet device

Jean-Christophe Dubois qemu-devel 1 version Applied

Status from this message: Applied to target-arm.next, thanks.

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest3 patches 1 replyApplied

Patches in v1 Applied

#Subject and filesSizeRepliesApplied
1/3Add a phy-num property to the i.MX FEC emulatorhw/net/imx_fec.c hw/net/trace-events include/hw/net/imx_fec.h+20 -90 replies
2/3Add the ability to select a different PHY for each i.MX6UL FEC interfacehw/arm/fsl-imx6ul.c include/hw/arm/fsl-imx6ul.h+12 -00 replies
3/3Select MDIO device 2 and 1 as PHY devices for i.MX6UL EVK board.hw/arm/mcimx6ul-evk.c+2 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/3] Allow to specify the PHY number to use with a specific i.MX FEC/ENET Ethernet device

The PHY device associated to a specific i.MX Ethernet device is not necessarily at address 0 on the MDIO bus.

This patch series adds the ability to set the PHY number on the MDIO bus for any i.MX6UL based board.

Jean-Christophe Dubois (3):
Add a phy-num property to the i.MX FEC emulator
Add the ability to select a different PHY for each i.MX6UL FEC
interface
Select MDIO device 2 and 1 as PHY devices for i.MW6UL EVK board.

 hw/arm/fsl-imx6ul.c         | 10 ++++++++++
 hw/arm/mcimx6ul-evk.c       |  2 ++
 hw/net/imx_fec.c            | 24 +++++++++++++++++-------
 hw/net/trace-events         |  4 ++--
 include/hw/arm/fsl-imx6ul.h |  2 ++
 include/hw/net/imx_fec.h    |  1 +
 6 files changed, 34 insertions(+), 9 deletions(-)
Signature · 1 line
2.25.1