Skip to content

mmc: zynq_sdhci: Add support for dynamic IP configuration

Michal Simek u-boot 1 version Applied

Status from this message: Applied.

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest4 patches 1 replyApplied

Patches in v1 Applied

#Subject and filesSizeRepliesApplied
1/4firmware: zynqmp: Add and update firmware enumsinclude/zynqmp_firmware.h+23 -00 replies
2/4firmware: zynqmp: Add support for set sd config and is function supporteddrivers/firmware/firmware-zynqmp.c include/zynqmp_firmware.h+57 -00 replies
3/4lib: div64: Add support for round up of div64_u64include/linux/math64.h+3 -00 replies
4/4mmc: zynq_sdhci: Add support for dynamic configurationdrivers/mmc/zynq_sdhci.c+99 -20 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/4] mmc: zynq_sdhci: Add support for dynamic IP configuration

Hi,

with SOM boards low level sdhci setting is not fully done. There are additional registers which are normally programmed via psu_init() but in this case they are not initialized. Information can be taken from DT and via firmware interface that values can be setup and that's exactly what this series is doing.

Thanks,
Michal

Ashok Reddy Soma (4):
firmware: zynqmp: Add and update firmware enums
firmware: zynqmp: Add support for set sd config and is function
supported
lib: div64: Add support for round up of div64_u64
mmc: zynq_sdhci: Add support for dynamic configuration

 drivers/firmware/firmware-zynqmp.c |  51 +++++++++++++++
 drivers/mmc/zynq_sdhci.c           | 101 ++++++++++++++++++++++++++++-
 include/linux/math64.h             |   3 +
 include/zynqmp_firmware.h          |  29 +++++++++
 4 files changed, 182 insertions(+), 2 deletions(-)
Signature · 1 line
2.35.1