Skip to content

ice: implement support for PTP on E822 hardware

Keller intel-wired-lan oe-kbuild-all 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest1 of 13 patches 0 repliesNew

1 of 13 patches is in this archive. The cover letter announces 13.

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
4/13ice: restart periodic outputs around time changes+0 -00 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [Intel-wired-lan] [net-next 00/13] ice: implement support for PTP on E822 hardware
Quoted 25 lines

-----Original Message-----
From: Paul Menzel <[email protected]>
Sent: Monday, July 05, 2021 12:47 AM
To: Keller, Jacob E <[email protected]>
Cc: intel-wired-lan at lists.osuosl.org
Subject: Re: [Intel-wired-lan] [net-next 00/13] ice: implement support for PTP on E822 hardware

Dear Jacob,

Thank you for sending the patches.

Am 01.07.21 um 02:27 schrieb Jacob Keller:

Quoted 8 lines

Extend the ice driver implementation to support PTP for the E822 based devices.

This includes a few cleanup patches, that fix some minor issues spotted while preparing them. In addition, there are some slight refactors to ease the addition of E822 support, followed by adding the new hardware implementation ice_ptp_hw.c.

Quoted 9 lines
Quoted 6 lines

There are a few major differences with E822 support compared to E810 support:

*) The E822 PHY is a bit different and requires a more complex initialization procedure that requires delaying the PHY start until link is up

It?d be great, if you gave concrete numbers.

Concrete numbers on which part? I'm not sure if we have concrete numbers on everything here. For the calibration process, according to the data sheet I have, it indicates that uncalibrated timestamps (i.e. in bypass mode) have an error of up to 1 clock cycle and calibrated timestamps should have an error of less than 1/8th of a clock cycle. Here clock cycle refers to the length of one tick on the clock source, and error refers to difference between actual start of reception or transmission vs time of when the timstamp is captured. I unfortunately am not at all sure how this was measured by the hardware folks...

Quoted 6 lines

[?]

Kind regards,

Paul