Skip to content

add basic driver support for broadcom NS3 soc

Thomas Fitzsimmons u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest0 of 15 patches 0 repliesNew

Patches in v1 No applies recorded yet

None of the 15 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH v1 00/15] add basic driver support for broadcom NS3 soc
Quoted 24 lines · Rayagonda Kokatanur
Quoted 23 lines · Tom Rini
Quoted 21 lines · Rayagonda Kokatanur

Hi Tom,

Quoted 16 lines · Tom Rini

Review

Quoted 9 lines · Rayagonda Kokatanur

This is the second patch set series prepared on top of the first patch set ("add initial support for broadcom NS3 soc").

This patch set will add following,

(quoted diff) +0 -4
-dt nodes and defconfig options for basic device like pinctrl,
 gpio, mmc, qspi, wdt, i2c and pcie.
-start wdt service
-Enable GPT commands
-Enable EXT4 and FAT fs support

All of the dts changes not in a -u-boot.dtsi file either come from mainline Linux or at least linux-next and have had some level upstream review, right? Thanks!

Quoted 7 lines
Quoted 5 lines
Quoted 2 lines

Yes. All the DTS changes are merged in the Linux and are available at arch/arm64/boot/dts/broadcom/stingray/

Great. Please reference the release you're taking these from as that will make future resyncs easier. Thanks!

It's Linux v5.6.

What's the relationship between e.g., bcm958742t.dts and ns3.dts? I looked at the mainline Linux device trees and I couldn't easily see the correspondence. Will the renaming complicate synchronization?

Thomas