PowerPC 8248
A message that is not in the archive (sent off-list or not yet received): -4679633020103399188@unknownmsgid
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Dear Sir：
I am a graduate student from Tsinghua University, China, I came to the
same problem that seems once you got and wrote on the PPC embeded forum, that, with u-boot 1.1.1 from freesacle, I can not port my 8248/8272 from 2.4to 2.6 kernel.
I saw your answer is that to edit "arch/ppc/platforms/pq2ads.h" and
change the "#define BCSR_ADDR ((uint) 0xf4500000)" to match the u-boot "u-boot/include/configs/MPC8260ADS.h".
I follow this, and it still no lucky, but there is a difference
between the two kernel, before I edited BCSR_ADDR, the new kernel just hang, after I edit it, the new kernel is just restart the right place where it hangs.
I got my kernel from kernel.org (2.6.13), and I wonder is there
something else I should pay attention, or got my kernel from someother place?
I am looking forward to your reply and best regards!
--
张乐
Zhangle
CERNET, Tsinghua University
[email protected]
Mobile: +861369-309-1200
Office: 010-62603928
Lab: 010-62603318
Addr: FIT 4-204, TSINGHUA UNIV., China
Lab Addr: FIT 1-210, TSINGHUA UNIV., China
Postcode: 100084
Signature · 10 lines
张乐 Zhangle CERNET, Tsinghua University [email protected] Mobile: +861369-309-1200 Office: 010-62603928 Lab: 010-62603318 Addr: FIT 4-204, TSINGHUA UNIV., China Lab Addr: FIT 1-210, TSINGHUA UNIV., China Postcode: 100084