Skip to contentSkip to conversation

PCI Memory mapping

DISCUSSION [email protected] 3 participants 3 messages Apr 15, 2011

lore
Share & tools
lore
#0 lore raw

Hi,

I have come across this forum, and I have a question. I am working on PCI device driver, I am trying to insert the pci card in to the pci slot of the main computer, I am finding a problem here, when I insert the card in to the pci slot, my pci device ID and vendor Id are not getting displayed. I am using windows xp o/s.

I am trying to map pci memory. Can you suggest me how can we map the pci memory. What steps should I take in order to make my Device Id and Vendor Id displayed when I insert the card in to the pci slot.

With Kind regards,

Ajith.

#1 lore raw
Quoted 5 lines

I have come across this forum, and I have a question. I am working on PCI device driver, I am trying to insert the pci card in to the pci slot of the main computer, I am finding a problem here, when I insert the card in to the pci slot, my pci device ID and vendor Id are not getting displayed. I am using windows xp o/s.

Err, so err, humm... er... how do I put this..?!

This is the "Linux on PowerPC" mailing list. Your question is neither Linux or PowerPC related.

I'm not sure how you expect anyone here to help.

Quoted 3 lines

I am trying to map pci memory. Can you suggest me how can we map the pci memory. What steps should I take in order to make my Device Id and Vendor Id displayed when I insert the card in to the pci slot.

Mikey

#2 lore raw
In reply to [email protected]

Hi Ajith,

Quoted 9 lines

I have come across this forum, and I have a question. I am working on PCI device driver, I am trying to insert the pci card in to the pci slot of the main computer, I am finding a problem here, when I insert the card in to the pci slot, my pci device ID and vendor Id are not getting displayed. I am using windows xp o/s.

I am trying to map pci memory. Can you suggest me how can we map the pci memory. What steps should I take in order to make my Device Id and Vendor Id displayed when I insert the card in to the pci slot.

This is a PowerPC Linux developer list so your question is way off-topic here.

If your PCI card is not showing up at all, it could be due to the fact that it is not being powered. I have found old motherboards that do not supply both the 5V and 3.3V rails to PCI slots. Check the power supplies on your PCI board, or at least measure the PCI power pins in the slots. Then if power is present, check there is a PCI clock in the slot. After that, boot Linux from a bootable CD-ROM and type lspci to see if your device is listed.

Cheers,
Dave