Hoontech Audio DSP24 Value (+bracket)
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 4 lines · On Tue, 12 Feb 2002, [email protected] wrote:
It is not possible to distinguish between a DSP24 Value and a DSP24 card in software. Also you cannot detect the converter on the card (as it is not needed).
so it would be necessary to specify the type of card and/or number of boxes when the driver loads ?
Quoted 4 lines
Quoted 1 line
The DAC & ADC volume don't seem to work though.
The hardware does not provide any function to change the input or output level of the analog I/O.
bugger. but the AK4524 supports changing the input gain, doesn't it ?
christof
Signature · 7 lines
Christof Damian Technical Director, guideguide ltd. _______________________________________________ Alsa-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/alsa-devel
Quoted 23 lines · On 12 Feb 2002, [email protected] wrote:
Hi,
Quoted 6 lines
Quoted 4 lines
Since your card was recognized as STDSP24, it means that both cards have the same sub vendor/device id. Thus it's difficult to guess which chip is. Perhaps trying to detect ak4524 at first, then one can recognize it as DSP24 Value or not.
I asked Hoontech about that too.
It is not possible to distinguish between a DSP24 Value and a DSP24 card in software. Also you cannot detect the converter on the card (as it is not needed).
The DSP24 PCI card provides a interface that is called "H-BUS" and allows you to connect several external boxes (ADC, DAC, Digital I/O interfaces, etc.) to one card. Via GPIO you can (and need to) controll this interface. Up to four external boxes with up to 4 stereo input channels on each box can be adressed at the same time. You can patch any of these stereo inputs to the Envy24 input by GPIO during runtime. This allows you for example to use a DS2000 (ADAT/TDIF interface) and a ADC&DAC2000 (analog I/O) at the same time and to switch between the inputs when needed. An introduction to this can be found on our
website: check www.staudio.com -> Service -> Knowledge Base -> DSP24 -> H-BUS.
Quoted 2 lines
The DSP24 Value simulates this by connecting the ADC on the card virtually as box number 1, input 1/2.
Box number 1 means the first from four? (Sorry, but addressing is from 0 to 3). Currently, ALSA initializes only first box at address zero.
Quoted 5 lines
Quoted 2 lines
The DAC & ADC volume
don't seem to work though.The hardware does not provide any function to change the input or output level of the analog I/O.
Thanks for clarification.
Jaroslav
-----
Jaroslav Kysela <[email protected]>
SuSE Linux http://www.suse.com
ALSA Project http://www.alsa-project.org
_______________________________________________
Alsa-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/alsa-devel