Skip to contentSkip to conversation

Got a machine, Got a Kernel Image, Got a Ramdisk Image, What's next?

parisc-linux Christopher L McNabb 2 participants 2 messages Nov 16, 1999

lore
Share & tools
lore
#0 lore raw

I've been using Intel Linux since version 0.99. My company recently retired an HP-9000 model 832, which is now sitting here in my house. I would love to help out with the pa-risc port, but don't have the time or inclination to do actual development. I can, however, do testing.

The box is an HP-9000 model 832, HP-UX 9.0, 32 Megs of RAM (yeah, I know that's rather low), and 3.5 gigs of hard drive space split between 6 HP-IB disk drives (4 internal, 2 external). A SCSI interface is supposed to arrive fed-ex today, and I will be adding a CD-ROM and SCSI disks as cash becomes available.

What I really need to know, though, are two things:
1. What is the process for getting the Linux kernel to boot?
2. What can I do to help with the porting of Linux to the PA-RISC architecture?

Christopher L McNabb
Senior Technical Specialist
SCT Corporation
work: [email protected]
home: [email protected]

#1 lore raw

Re:

Quoted 5 lines

The box is an HP-9000 model 832, HP-UX 9.0, 32 Megs of RAM (yeah, I know that's rather low), and 3.5 gigs of hard drive space split between 6 HP-IB disk drives (4 internal, 2 external). A SCSI interface is supposed to arrive fed-ex today, and I will be adding a CD-ROM and SCSI disks as cash becomes available.

I can't remember if the original 8x2 machines could boot from SCSI. Their immediate predecessors, the 8x5 machines, couldn't (but the ability was added later via a firmware upgrade).

That aside, 8x2 machines are a slightly older version of PA-RISC (1.0? 1.1?). The 9000/7xx and most newer 9000/8xx machines are running newer versions of PA-RISC (1.2 or later). The most important difference is in floating point instructions. The PA-RISC kernel *could* be easily compiled for 1.0 architecture... I doubt that it does much floating point work in the kernel! Further, it could be compiled with 1.2 scheduling...that still works on 1.0 machines.

The I/O architecture is HP-PB, like the 8x7 machines, so that may be okay.

If it turns out that the current port won't work for you, you have a few choices:

1) wait for it to be done, and modify it for 8x2.

2) use your 832 with HP-UX. You can go to
http://www.software.hp.com/y2kupgrades/
and get HP-UX 10.20 for free.

3) trade it for a machine supported by the current porting project.

If you opt for (3), you may want to know about the Classic Computer mailing list ... a worldwide group of computer collectors. To post a message to it, send to:
[email protected]

The 832 is a 30 MHz machine.

Signature · 2 lines
Stan Sieler                                           [email protected]
www.allegro.com/sieler/wanted/index.html          www.allegro.com/sieler