Skip to contentSkip to conversation

SSSSlllloooowwww MPC8240

DISCUSSION Jerry Van Baren 2 participants 2 messages Jul 10, 2001 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive

Is caching enabled (both instruction and data)? It sounds a lot like you are running without the benefit of caches. Another possibility is that you are being swamped with interrupts, but I vaguely recall that should not be a problem for the start up bogomips calculation.

gvb

Quoted 13 lines · At 06:57 PM 7/9/01 -0400, [email protected] wrote:

Can anybody suggest why I'm seeing the following:

Under Hard Hat Linux 2.0 (2.4.2 kernel) on my MVME2100 board (MPC8240 CPU running at 200MHz), Linux startup reports a BogoMIPS rating of 9.59. I've just built and run the exact same calibration code under vxWorks, and here I get a rating of 133.73 BogoMIPS, which seems much more likely to be correct. Linux does seem rather sluggish at running things, so I don't think it's problem with the calibration. Any ideas what could be going on behind the scenes to slow Linux down, and how I might track it down?

I wonder whether it's related to that openpic interrupt stuff in the other thread...

Quoted 7 lines

TIA,

- Andrew
--
The world is such a cheerful place when viewed from upside-down It makes a rise of every fall, a smile of every frown

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#2 lore raw
Quoted 3 lines · Jerry Van Baren

Is caching enabled (both instruction and data)? It sounds a lot like you are running without the benefit of caches.

That was it - thanks Jerry, I now get 133.12 BogoMIPS and a much more responsive machine.

- Andrew
--
The world is such a cheerful place when viewed from upside-down It makes a rise of every fall, a smile of every frown

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/