Skip to contentSkip to conversation

Serial & Framebuffer Console together

U-Boot-Users Praveen VS 1 participant 1 message Feb 23, 2005

lore
Share & tools
lore

Praveen VS

author
#0 lore raw

Hello,

Our board is customised board based on PXA255 processor, in that we have the samsung Color LCD Controller( S6B33B0A) .

The LCD is not interfaced to the Default PXA255 LCD pins. IN our board the LCD controller ChipsSelect is connected to the Static Chipselect 4 of PXA255
The LCD is a 16bpp LCD.

We are able to initialise the LCD. We are able to get the plain colors sucessfully.
We are trying to display u-boot logo on this 16bpp LCD.But it is not displaying..

When we looked at code bmp_logo.c , we found utility called bmp_logo, which converts bmp file into header
This header file is for 8 bpp & has a bmp palette field. It tries to write the Pallette info on to Palette Ram of PXA255.

But our LCD controller is external & doesn't have pallette RAM.It only has a standard DisplayRAM
The 16 bit colors which this controller supports doesn't have the Pallete information.

How can we display the logo of 16bpp color depth image onto the LCD.in U-boot?

Thanks
Reagrds
Praveen

-----Original Message-----
From: Praveen VS [mailto:praveen at spacomp.com]
Sent: Wednesday, February 09, 2005 11:06 AM
To: 'wd at denx.de'
Cc: 'u-boot-users at lists.sourceforge.net'
Subject: RE: [U-Boot-Users] Serial & Framebuffer Console together

Hello ,]
Thanks for you mail.
We are trying to draw logo on to the LCD Screen, we are not able to see anything on it.. Regards Praveen

-----Original Message-----
From: [email protected] [mailto:wd at denx.de]
Sent: Tuesday, February 08, 2005 9:44 PM
To: praveen at spacomp.com
Cc: u-boot-users at lists.sourceforge.net
Subject: Re: [U-Boot-Users] Serial & Framebuffer Console together

Quoted 9 lines · In message <001301c50df7$99e60900$0400a8c0@praveenvs> you wrote:

After initialising we are getting the shell prompt on stdout(serial) In that when we did the cninfo we got the following.. $ coninfo List of available devices:

lcd      00000002 ..O
serial   80000003 SIO stdin stdout stderr
nulldev  80000003 SIO 

We are not sure if the lcd console info is correct..

What is not clear to you? As you can see in your log the LCD device has been registered as an output device, and input and poutput are directed to the serial port. So everything looks perfectly fine to me. What did you expect?

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de In
the bathtub of history the truth is harder to hold than the  soap,
and much more difficult to find ...     - Terry Pratchett, _Sourcery_