Skip to contentSkip to conversation

partition table: chs question

DISCUSSION Jeff V. Merkey 1 participant 1 message Feb 26, 2001

lore
Share & tools
lore
#0 lore raw

----- Original Message -----
From: "Jeff V. Merkey" <[email protected]>
To: "Guest section DW" <[email protected]>; "Andreas Jellinghaus" <[email protected]>; <[email protected]>
Sent: Sunday, February 25, 2001 5:02 PM
Subject: Re: partition table: chs question

Quoted 6 lines

Please also check vger.timpanogas.org/nwfs/nwfs.tar.gz:disk.c for NetWare specific calculations of the CHS values, a different method is used for NetWare partitions vs. everything else (Novell just had to be different). If you do not use their methods on NetWare partitions, NetWare will not recognize the partition entries correctly, and will attempt to

reinitialize

Quoted 6 lines

the entire partition table on a system if they are wrong (Ouch!). NetWare does a different calculation for conversion of cylinder values above 1024.

Jeff

Quoted 22 lines

----- Original Message -----
From: "Guest section DW" <[email protected]>
To: "Andreas Jellinghaus" <[email protected]>;
<[email protected]>
Sent: Sunday, February 25, 2001 2:47 PM
Subject: Re: partition table: chs question

Quoted 14 lines · Andreas Jellinghaus
Quoted 10 lines

for partitions not in the first 8gb of a harddisk, what should the c/h/s start and end value be ?

most fdisks seem to set start and end to 255/63/1023. but partition magic creates partitions with start set to 0/1/1023 and end set to 255/63/1023, and detects a problem if start is set to 255/63/1023.

so, how should a partition table look like ?

Since these values will never be used you can imagine that they are not of great interest. Do whatever you like.

This statement is not true of NetWare partitions. They are used to validate whether or not the partition table has been corrupted.

Jeff

Quoted 2 lines
Quoted 2 lines

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel"

in

Quoted 4 lines
Quoted 3 lines

the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/