Skip to contentSkip to conversation

usbtty windows driver

U-Boot-Users Chris Boger 1 participant 1 message Dec 8, 2006

lore
Share & tools
lore
#0 lore raw

Hello all,

I *think* that I have properly ported the usbtty functionality to my XScale-based board, but I'm having some issues using it via a Windows host. I started off thinking that once implemented, this would be recognized by Windows (using the proper INF file) and use the built-in usbser.sys driver on my Windows XP host. But, I've been having a heck of a time getting that to work.

My device is enumerates and passes the USB-IF chapter 9 compliance tools just fine. It shows up in the Device Manager under the Ports section as a COM port with a yellow slash over it. After digging deeper into the code and the USB documentation, I see that u-boot's usbtty doesn't seem follow the Serial Emulation Abstract Control Model (section 3.6.2.1 of the CDC spec) like I thought it did. In fact, USBTTY_INTERFACE_CLASS is defined as 0xFF (vendor specific) and not 0x02 (communication class). I also noticed that we don't use the interrupt IN endpoint at all.

So, am I totally wrong here or does our usbtty require a custom Windows device driver?

Best Regards,
Crhis