Skip to contentSkip to conversation

BTRFS EFI Boot question

DISCUSSION Lucas Smith 3 participants 3 messages Feb 5, 2015 – Feb 6, 2015 Btrfs file system

lore
Share & tools
lore
#0 lore raw

Hey folks!

Having a confusing question brought up to me by my Debian Testing installer and am unsure what the implications are for it. I want to run btrfs in RAID10 on 4x1TB WD RE3 drives. Apparently, my system is set up to boot using EFI. Are there any reasons not to use EFI Booting in this circumstance?

#1 lore raw

Unless you're putting the EFI System Partition (ESP) on the RAID10, you should be fine.

Note that the ESP also needs ot be FAT32, so you can't have it as a part of your btrfs RAID10 array, so if that's what you are asking, it can't be done. An ESP located somewhere else should still be able to boot from a rootfs in the RAID10 however, so your OS can be on the RAID.

Signature · 1 line
Zia Nayamuth
Quoted 11 lines · Lucas Smith

Hey folks!

Having a confusing question brought up to me by my Debian Testing installer and am unsure what the implications are for it. I want to run btrfs in RAID10 on 4x1TB WD RE3 drives. Apparently, my system is set up to boot using EFI. Are there any reasons not to use EFI Booting in this circumstance?

--
To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

#2 lore raw
In reply to Lucas Smith
Quoted 7 lines · Lucas Smith

Hey folks!

Having a confusing question brought up to me by my Debian Testing installer and am unsure what the implications are for it. I want to run btrfs in RAID10 on 4x1TB WD RE3 drives. Apparently, my system is set up to boot using EFI. Are there any reasons not to use EFI Booting in this circumstance?

I'm using UEFI boot with btrfs RAID-1 on three devices (including bcache meanwhile). It works without problems. The only caveat is, that for both, bcache and multi-device btrfs (or combination of both) you need to boot using initramfs because the kernel by itself can neither detect multi-device btrfs not initialize bcache. This applies if you want to use it for the rootfs.

You are all fine if rootfs is something more traditional.

My layout is having the ESP (mounted as /boot), a resume swap and bcache caching device on an SSD, the rest is 3x 1TB spinning rust with btrfs, containing root and all the other subvolumes.

Signature · 1 line
Replies to list only preferred.