Strange problem with Device Mapper
Hello,
I've a machine that has been installed with Intel Soft Raid on top of 2 SATA disks.
I'm trying to have this work as a RAID-1 array.
Bios configuration has been done, using 128K chunk, and the kernel (2.6.20.7) sees perfectly /dev/mapper/isw_xxxxxxxx_RAID1
But, I'm facing two problems :
1 - If i try to create partitions on this device, it does fail (the
values are not interpreted correctly)
2 - To avoid 1), I stop the RAID array (dmraid -an), then I do create
exactly the same partition set on /dev/sda, and /dev/sdb, and then I reactivate RAID (dmraid -ay).
This allows me to see all the /dev/mapper/isw_xxxxxxx_RAID1p1, p2, ... But, running fsck -t ext2 /dev/mapper/isw_xxxxxxx_RAID1p1 ends in a lock when the partition is larger than 10Go (well, it is Ok on the 10Go one, and it locks on the 100Go).
Not a real hardlock, I still can switch to a new VC, but it's not more possible to start a new command or to stop fsck.
Should I do everything on the physical disks before activating RAID ? Is it a normal behavior ?
BTW, I also noticed that such a device doesn't support BLKRRPART ioctl... So it is possible that what I'm doing is wrong...
Any idea ?
Regards,
Paul
Quoted 22 lines · On Thu, 26 Apr 2007 19:12:27 +0200 "Paul Rolland" <[email protected]> wrote:
Hello,
I've a machine that has been installed with Intel Soft Raid on top of 2 SATA disks.
I'm trying to have this work as a RAID-1 array.
Bios configuration has been done, using 128K chunk, and the kernel (2.6.20.7) sees perfectly/dev/mapper/isw_xxxxxxxx_RAID1But, I'm facing two problems :
1 - If i try to create partitions on this device, it does fail (the
values are not interpreted correctly)2 - To avoid 1), I stop the RAID array (dmraid -an), then I do create
exactly the same partition set on/dev/sda, and/dev/sdb, and then I reactivate RAID (dmraid -ay).
This allows me to see all the/dev/mapper/isw_xxxxxxx_RAID1p1, p2, ... But, running fsck -t ext2/dev/mapper/isw_xxxxxxx_RAID1p1ends in a lock when the partition is larger than 10Go (well, it is Ok on the 10Go one, and it locks on the 100Go).
Not a real hardlock, I still can switch to a new VC, but it's not more possible to start a new command or to stop fsck.
Quoted 8 lines
Should I do everything on the physical disks before activating RAID ? Is it a normal behavior ?
BTW, I also noticed that such a device doesn't support BLKRRPART ioctl... So it is possible that what I'm doing is wrong...
Any idea ?
cc added.