Programming ethernet PHY by SPI on MPC8360E-RDK
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): 3026DA9FE767E2418FA2C568FE4F5CB16B10B8A5AE@ILPTMAIL02.ecitele.com
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 9 lines
I have been scouring the code (u-boot) to see evidence of using SPI to configure the ethernet PHY. I do not find anything that is obvious. The board uses BMC54XX ethernet transciever. I will appreciate any insight from you .
I was able to locate and use QE configuration of IO pins. Many thanks.
Sampath
Sorry, can't help you here.
Maybe somoene from the u-boot list has better knowledge of this?