Skip to contentSkip to conversation

irq 3: nobody cared! with Intel 31244 SATA.... Advice??

DISCUSSION David Sims 1 participant 1 message Jan 24, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): 007201c501c1$fb2c2f60$0d65a8c0@SHARK

David Sims

author
#1 lore raw

Hi Atul,

If I enable APIC on the 2.6.10 kernel I get exactly the same behavior as
I got without APIC.... If I enable APIC-IO, then it starts barking about Interrupt 22 and never finishes... SO... At the minimum, both of these settings do not help and one makes the problem worse in that the sata-vsc module never finishes loading....

Thanks for your response though... At this point I am ready to climb a
tree and bark at the moon if it will help.... ;)

Dave
************************************************************************

Quoted 22 lines · Atul Bhouraskar
Quoted 8 lines

-----Original Message-----
From: [email protected] [mailto:linux-kernel- [email protected]] On Behalf Of David Sims
Sent: Monday, 24 January 2005 13:57

I then downloaded and built kernel 2.6.10 which boots up fine without

the

Quoted 1 line

sata_vsc module.... If you then load the sata_vsc module manually

using

Quoted 5 lines

"modprobe sata_vsc" it will cause the following error once for each attached disk drive:

Jan 23 09:08:21 linux kernel: Disabling IRQ #3
Jan 23 09:08:23 linux kernel: irq 3: nobody cared!

I once had the same problem, I think enabling APIC solved it....

Atul