Bond feature can't running well on 40G i40e NICs
Hi DPDK maintainers,
We encounter confusion recently which is 40G i40e NICs bond issue, our bonding logic as below, the ixgbe bonding is running well both 1.7.1 and 1.8.0, but i40e are all failed.
Create bond port -> config slave ports(tx/rx) -> start slave ports -> add slave port into bond port -> start bond port -> tx/rx on bond port
On 1.7.1, the 40G bonding port always can't be started, them status are down and speed are 0.
On 1.8.0, the 40G bonding port start and send network package correctly, but can't receive any package with BONDING_MODE_BALANCE
<http://www.dpdk.org/doc/api/rte__eth__bond_8h.html#a6a70bf21c5b4ad3a1368615349cb9771> mode and all policies like BALANCE_XMIT_POLICY_LAYER2. In BONDING_MODE_ROUND_ROBIN
<http://www.dpdk.org/doc/api/rte__eth__bond_8h.html#aad34f918b8877dc6a27322d03dc4184f> mode, bonding port can send/receive a few network packages(less than 100) per seconds.
Could you please help us for this? any clue is welcome.
Thanks and Regards,
Haifeng
Quoted 35 lines · lhffjzh
Hi DPDK maintainers,
We encounter confusion recently which is 40G i40e NICs bond issue, our bonding logic as below, the ixgbe bonding is running well both 1.7.1 and 1.8.0, but i40e are all failed.
Create bond port -> config slave ports(tx/rx) -> start slave ports -> add slave port into bond port -> start bond port -> tx/rx on bond port
On 1.7.1, the 40G bonding port always can't be started, them status are down and speed are 0.
On 1.8.0, the 40G bonding port start and send network package correctly, but can't receive any package with
BONDING_MODE_BALANCE
<http://www.dpdk.org/doc/api/rte__eth__bond_8h.html#a6a70bf21c5b4ad3a1368615349cb9771> mode and all policies likeBALANCE_XMIT_POLICY_LAYER2. InBONDING_MODE_ROUND_ROBIN
<http://www.dpdk.org/doc/api/rte__eth__bond_8h.html#aad34f918b8877dc6a27322d03dc4184f> mode, bonding port can send/receive a few network packages(less than 100) per seconds.Could you please help us for this? any clue is welcome.
Quoted 6 lines
Thanks and Regards,
Haifeng
Hi Haifeng,
We only added support from i40e devices in the 1.8.0 release. In release 1.7.0/1.7.1 there was no support for LSC interrupts in the i40e PMD which was required for that release of the bonding PMD, this is why the device cannot be started and will always stay have a link down status, as the bonded PMD isn't able to detect the LSC in the slave. From 1.8.0 support was added for polling of PMD's LSC where interrupts aren't supported, but LSC interrupt support for the i40e PMD was also added in this release.
I need to investigate this further and see if I can replicate your issues. I'll reply as soon as I have further information.
Declan