Touch Screen: support on OMAP 3430
Subsystems (5)
PATCH 4/5 Touch Screen: support on OMAP 3430
This patch supports Touchscreen on 3430
Signed-off-by Girish S G <[email protected]>
--- arch/arm/configs/omap_3430sdp_defconfig | 3 - arch/arm/mach-omap2/board-3430sdp.c | 90 ++++++++++++++++++++++++++++++ drivers/input/touchscreen/ads7846.c | 9 +++ include/asm-arm/arch-omap/board-3430sdp.h | 9 +++ include/asm-arm/arch-omap/gpio.h | 2 include/linux/spi/ads7846.h | 5 + 6 files changed, 116 insertions(+), 2 deletions(-)
arch/arm/configs/omap_3430sdp_defconfig +2 -1
@@ -549,7 +549,8 @@ # CONFIG_INPUT_MOUSE is not set # CONFIG_INPUT_JOYSTICK is not set # CONFIG_INPUT_TABLET is not set -# CONFIG_INPUT_TOUCHSCREEN is not set +CONFIG_INPUT_TOUCHSCREEN=y +# CONFIG_TOUCHSCREEN_ADS7846 is not set # CONFIG_INPUT_MISC is not set #
arch/arm/mach-omap2/board-3430sdp.c +90 -0
120 lines not on this page · raw message
include/asm-arm/arch-omap/board-3430sdp.h +9 -0
@@ -36,6 +36,15 @@#define OMAP34XX_ETHR_START DEBUG_BASE#define OMAP34XX_ETHR_GPIO_IRQ 29 +/* +* GPIO used for TSC2046, TI's Touchscreen controller +*/ +#ifdef CONFIG_OMAP3430_ES2 +#define TS_GPIO 2 +#else +#define TS_GPIO 3 +#endif +/* NAND */ /* IMPORTANT NOTE ON MAPPING * 3430SDP - 343X
include/asm-arm/arch-omap/gpio.h +1 -1
@@ -80,7 +80,7 @@extern void omap2_gpio_prepare_for_retention (void );extern void omap2_gpio_resume_after_retention (void ); -#ifdef CONFIG_ARCH_OMAP24XX +#if defined(CONFIG_ARCH_OMAP24XX ) || defined(CONFIG_ARCH_OMAP34XX )extern void omap_set_gpio_debounce (int gpio,int enable);extern void omap_set_gpio_debounce_time (int gpio,int enable);#endif
include/linux/spi/ads7846.h +5 -0
@@ -47,5 +47,10 @@ void **filter_data);int (*filter) (void *filter_data,int data_idx,int *val);void (*filter_cleanup)(void *filter_data); + +/* controls enabling/disabling*/ +int (*vaux_control)(int vaux_cntrl); +#define VAUX_ENABLE 1 +#define VAUX_DISABLE 0 };
drivers/input/touchscreen/ads7846.c +9 -0
@@ -838,6 +838,15 @@return -ENODEV ; } +/* enable voltage */ +if (pdata->vaux_control !=NULL ) { + err = pdata->vaux_control (VAUX_ENABLE ); +if (err !=0 ) { +dev_dbg (&spi->dev,"TS vaux enable failed\n" ); +return err; + } + } +/* don't exceed max specified sample rate */ if (spi->max_speed_hz > (125000 *SAMPLE_BITS )) { dev_dbg(&spi->dev, "f(sample) %d KHz?\n",
Tony Lindgren
maintainerQuoted 1 line · Girish
This patch supports Touchscreen on 3430
Pushing today.
Tony