Skip to contentSkip to conversation

Anyone get the TI/PowerVR stuff working?

DISCUSSION [email protected] 3 participants 3 messages Feb 3, 2009 – Feb 4, 2009

lore
Share & tools
lore
#0 lore raw

Does anyone on the list have any experience getting the (unfortunately proprietary) PowerVR drivers for the OMAP3 working under Linux and X?

I've registered with TI, and downloaded the SDKs for the ZOOM and SDP boards, and cannot work out how to integrate them into what I've built on my prototype.

Also, I'm trying to get the DSP bridge stuff working.

Any good advice would be appreciated.

#1 lore raw

Op 3 feb 2009, om 20:45 heeft [email protected] het volgende geschreven:

Quoted 2 lines

Does anyone on the list have any experience getting the (unfortunately proprietary) PowerVR drivers for the OMAP3 working under Linux and X?

Yes: http://www.youtube.com/watch?v=3ToYOgP9f9U&feature=channel_page

The samurai and proxycon are FB demos, but clutter works with X11 (Xorg, not Xsgx).

Quoted 3 lines

I've registered with TI, and downloaded the SDKs for the ZOOM and SDP boards, and cannot work out how to integrate them into what I've built on my prototype.

I have the 1.3.1397 GPLv2 kernel drivers working (http://www.bat.org/~tomba/git/omap3-sgx.git/) working with the yet-to-be-released 1.3.1397 userspace and Tomi's DSS2 patches. The release is scheduled to be 'soon', but I've heard rumours that WTBU customers can download it already.

regards,

Koen

#2 lore raw

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Koen Kooi
Sent: Wednesday, February 04, 2009 1:50 AM
To: [email protected] List
Subject: Re: Anyone get the TI/PowerVR stuff working?

I have the 1.3.1397 GPLv2 kernel drivers working (http://www.bat.org/~tomba/git/omap3-sgx.git/
) working with the yet-to-be-released 1.3.1397 userspace and Tomi's
DSS2 patches. The release is scheduled to be 'soon', but I've heard
rumours that WTBU customers can download it already.

Quoted 1 line

When I tried last using DSS2, I was getting "no flipping error" and flickery output. Is there a fix for this ?

Regards,
Pratheeh