2.4.17-pre2 having dma problems with atapi devices
I'm trying to write to a cd at 8x, which i could do in prior kernels (2.4.15-prex and before), but now i'm getting cdrecord errors and sometimes dma timeouts. Seems that data is being corrupted somewhere again. I got this kind of performance when i had it on the promise controller and when i moved it back to my via controller it worked perfectly.
Ide controller:
VIA vt82c686a (rev 22) IDE UDMA66 controller
CDR : CREATIVE CD-RW RW8438E, ATAPI CD/DVD-ROM drive (set as master and DMA set by kernel)
setting to a lower write speed allows successful writes.
cdrecord error:/usr/bin/cdrecord: Input/output error. send opc: scsi sendcmd: no error
CDB: 54 01 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 73 03 00 00 Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x73 Qual 0x03 (power calibration area error) Fru 0x0 Sense flags: Blk 0 (not valid)
cmd finished after 17.724s timeout 60s/usr/bin/cdrecord: Resource temporarily unavailable. OPC failed. /usr/bin/cdrecord: fifo had 64 puts and 0 gets. /usr/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
The dma errors weren't very special, same old dma timeout and reset
messages. The cds are perfectly fine, i use the same one that errored
at 4x and it reads fine after burn.