Skip to contentSkip to conversation

2.4.16 / 2.4.17pre6 hang when loading agpgart

DISCUSSION Roel Teuwen 2 participants 2 messages Dec 9, 2001

lore
Share & tools
lore
#0 lore raw

Hi all,

On my HP Omnibook 4150, 2.4.16 and 2.4.17-pre6 hang on boot right after the messages below.
I need to press the reset button and load a kernel without agpgart compiled in to boot. When compiled as a module, the machine hangs after printing these lines when loading the module.

"
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory : 96M
agpgart: Detected Intel 440BX chipset
"

I selected the agpgart "440BX" option in menuconfig. AGP information :

00:01.0 PCI bridge: Intel Corp. 440BX/ZX - 82443BX/ZX AGP bridge (rev
02) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 128
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 Memory behind bridge: fe700000-fecfffff Prefetchable memory behind bridge: fd000000-fe3fffff

Please tell me if more information is needed.

Best regards,

Roel

#1 lore raw
Quoted 15 lines · Roel Teuwen

On my HP Omnibook 4150, 2.4.16 and 2.4.17-pre6 hang on boot right after the messages below.
I need to press the reset button and load a kernel without agpgart compiled in to boot. When compiled as a module, the machine hangs after printing these lines when loading the module.

"
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory : 96M
agpgart: Detected Intel 440BX chipset
"

I selected the agpgart "440BX" option in menuconfig. AGP information :

Quoted 6 lines

00:01.0 PCI bridge: Intel Corp. 440BX/ZX - 82443BX/ZX AGP bridge (rev
02) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 128
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 Memory behind bridge: fe700000-fecfffff Prefetchable memory behind bridge: fd000000-fe3fffff

I had the same problem after upgrading the BIOS on a Trigem Napoli-2 mainboard with a 440BX (eMachine 500a). Tested with kernels 2.4.5-RH through 2.4.13-ac7. With Bios image v1.12 it hangs with agpgart built in or on module load exactly as you described, it also fails when I use nvidia's NVdriver agp support. After upgrading to Bios 1.13 the problem went away.

Something to check for anyway...

For completeness, my working setup displays the normal kernel apggart info and shows this:

00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 03) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 64
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: fc600000-fe6fffff Prefetchable memory behind bridge: f0400000-f44fffff

Regards,
Reid