2.4.16 / 2.4.17pre6 hang when loading agpgart
Hi,
Quoted 1 line
On my HP Omnibook 4150, 2.4.16 and 2.4.17-pre6 hang on boot right
after
Quoted 3 lines
the messages below.
I need to press the reset button and load a kernel without agpgart compiled in to boot. When compiled as a module, the machine hangs
after
Quoted 2 lines
printing these lines when loading the module.
I also have an HP Omnibook 4150 (model F1629N, PII 300 MHz and Neomagic NM2200 card) and I have similar problems (if I try to load the agpgart module it locks up the machine). Some time ago I did a bit of debugging and I arrived to the conclusion that the BIOS does not initialize the base of the aperture table (that can be seen by reading the APBASE register of the PCI AGP controller or by doing "lspci -v" and seeing that the memory is unassigned). That locks up the system whenever AGP is enabled by the agpgart module (will try to access memory at 0x0).
Have you ever managed to get agpgart working on the OB 4150? If yes, which exact model and with which BIOS on which kernel?
I'm using BIOS 2.28 and running kernel 2.4.9-13 (RedHat 7.2).
Relevant lspci data is:
00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 02)
Flags: bus master, medium devsel, latency 64
Memory at <unassigned> (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0
00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 02) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 128
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 Memory behind bridge: fe700000-fecfffff Prefetchable memory behind bridge: fd000000-fe3fffff
As you can see, 00:00.0 has the memory unassigned. I guess the BIOS should set that up.
Any feedback very much appreciated!
Diego
PS: I'm not on lkml so a CC would be appreciated. More info on my HP 4150 setup at http://ltswww.epfl.ch/~dsanta/resources/hp4150-linux
Signature · 11 lines
------------------------------------------------------- Diego Santa Cruz PhD. student Publications available at http://ltswww.epfl.ch/~dsanta Signal Processing Laboratory (LTS) Swiss Federal Institute of Technology (EPFL) EPFL - DE - LTS, CH-1015 Lausanne, Switzerland E-mail: [email protected] Phone: +41 - 21 - 693 26 57 Fax: +41 - 21 - 693 76 00 -------------------------------------------------------