Skip to contentSkip to conversation

How to change the preferred minor

DISCUSSION Anders Nielsen 1 participant 2 messages Apr 10, 2002 – Apr 11, 2002 1 message not in the archive MD RAID

lore
Share & tools
lore
#0 lore raw

When I try to boot my box with disks which previously was configured in other machines md tries to autodetect which array should have a given minor number.

I use the wonderful :-) mdadm -E and I can see a preferred minor value which is very nice, but since more than one array is competing for the same minor number it is kind of difficult for me to figure out what to put in my /etc/fstab.

Therefore my question is: how do I change the preferred minor value on a array so I can prevent conflicts? I would of course like to be able to use mdadm for this job :-)

Thanks,
Anders Nielsen

#2 lore raw
In reply to a message not in the archive

tor, 2002-04-11 kl. 02:56 skrev Neil Brown:

Quoted 21 lines · On April 10, [email protected] wrote:
Quoted 4 lines

When I try to boot my box with disks which previously was configured in other machines md tries to autodetect which array should have a given minor number.

Quoted 8 lines

I use the wonderful :-) mdadm -E and I can see a preferred minor value which is very nice, but since more than one array is competing for the same minor number it is kind of difficult for me to figure out what to put in my /etc/fstab.

Therefore my question is: how do I change the preferred minor value on a array so I can prevent conflicts? I would of course like to be able to use mdadm for this job :-)

This would be one of the reasons that I neither use nor recommend RAID autostart. It is too dependant on the preferred-minor which is hard to change.
I guess I could add an option to mdadm to change the preferred-minor as it could be useful, but I'm not highly motivated. Maybe a --rewrite-superblock option to --assemble...

Quoted 6 lines

I recommend that you enumerate the uuids of your arrays, create /etc/mdadm.conf to say which uuid matches which /dev/md? and use
mdadm --assemble --scan
to assemble your arrays.

NeilBrown

I see that the method you recommend is more flexible since there are more uuids than minor numbers :-)

But I am not sure how I disable autostart and replace it with mdadm -A --scan so I could use some help.

I am using Redhat 7.2. I guess I have to change an initscript or something.

Thanks,
Anders