USB Audio/Midiman - partial success
A message that is not in the archive (sent off-list or not yet received): 1031436425.5282.7.camel@Home
A message that is not in the archive (sent off-list or not yet received): [email protected]
At Sat, 7 Sep 2002 16:07:15 -0700 (PDT),
Quoted 4 lines · Fedor G. Pikus
I got something out of the Midiman Duo, but still not quite as good as under Windows:
Quoted 10 lines
If I use usb-uhci module for my USB controller, I get 2 PCMs, pcm0 supports recording at 44.1KHz (arecord -f cd), and works fine. pcm1 supports recording at 44.1KHz ok, and also at 48KHz, but when I try that, I get this in the log:
usb-uhci.c: interrupt, status 2, frame# 1646
ALSA../alsa-kernel/usb/usbaudio.c:628: timeout: still 5 active urbs.. usb_control/bulk_msg: timeoutusb.c: USB disconnect on device 4
And after this I have no USB at all until reboot. USB mouse does not work, nothing.
this might be because you got xrun, and there was a problem in usb-audio driver in this regard. please try the cvs version. the hang-up should have been fixed.
also, Patrick reported that the capture works firstly after playing (setting up) the playback device before capture on his quattro. your device may have a similar problem.
Quoted 6 lines
If instead I use uhci module, I get only one PCM, pcm0, and it supports 44.1KHz, and works fine.
Why doesn't 48KHz work, and where are higher rates, where is 24bit recording?
hmm, uhci driver cannot get the whole descriptor properly in comparison with usb-uhci driver.
please compares the outputs of lsusb from both modules.
Takashi
-------------------------------------------------------
This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE!
https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390