PDC20276 Linux driver
A message that is not in the archive (sent off-list or not yet received): 1037192260.1501.1.camel@darkstar
Quoted 3 lines · Freaky
I couldn't install slackware at all, even with my home compiled kernel. It just doesn't recognize the /dev/ataraid/d?p? drives and tells me there are no disks with ext2 filesystems when I try to start setup.
You can simply mount /dev/ataraid/d?p? on /mnt and start the slackware installation setup script skipping the selection of the target, the swap and the lilo configuration; after istallation is completed, you can edit /etc/fstab and /etc/lilo.conf as you whish.
Quoted 1 line
You need the ataraid drivers for the pdc don't you?
I compiled the kernel with PDC202XX driver, with ataraid and with FastTrak ataraid driver.
Quoted 1 line
How did you compile pdc without ataraid?
I tryed to compile pdc202xx and not ataraid to try to use software raid. Is this the answer you were lookig for?
In all the cases my pdc20276 hangs after about half a gigabyte written into any disk.