Skip to contentSkip to conversation

Alsa kernel questionS

DISCUSSION Nicolas Mailhot 2 participants 2 messages Feb 16, 2003 – Feb 17, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

I've got a Hercules Fortissimo III 7.1 :

00:0a.0 Multimedia audio controller: Cirrus Logic CS 4614/22/24 [CrystalClear SoundFusion Audio Accelerator] (rev 01)
Subsystem: Hercules Fortissimo III 7.1
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort-
<TAbort-
<MAbort- >SERR- <PERR-

        Latency: 32 (1000ns min, 6000ns max)
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at e9100000 (32-bit, non-prefetchable)
[size=4K]
        Region 1: Memory at e9000000 (32-bit, non-prefetchable)

[size=1M]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I use it *only* via the optical output.

Now it seems the alsa driver that's in 2.5 with mute the optical output until black magic is performed in any alsa-compatible mixer.

Is there any boot option to tell alsa to activate the optical output automatically ?

The second question is, with the alsa tools present on freshrpms.net and optical output activated, the only mixer setting that seem to have an effect is the DAC.

Is there a way to set this knob as the default sound volume (as a kernel boot option ...) ?

Why is the dac controlling the volume even when I'm reading a CD (i.e. digital PCM input, digital optical output, what is the DAC doing here) ?

Sorry about the stupid questions, I found lots of material on building alsa (not really needed now it's in-kernel) but little on how to use it:(

Regards,

Signature · 1 line
Nicolas Mailhot
#1 lore raw

At 16 Feb 2003 17:24:23 +0100,

Quoted 6 lines · Nicolas Mailhot

Now it seems the alsa driver that's in 2.5 with mute the optical output until black magic is performed in any alsa-compatible mixer.

Is there any boot option to tell alsa to activate the optical output automatically ?

no, not via a kernel boot option.

Quoted 6 lines

The second question is, with the alsa tools present on freshrpms.net and optical output activated, the only mixer setting that seem to have an effect is the DAC.

Is there a way to set this knob as the default sound volume (as a kernel boot option ...) ?

no, not via a kernel boot option.

please set up your init script or module.conf appropriately. you can restore the configuration simply by calling "alsactl restore".

Quoted 2 lines

Why is the dac controlling the volume even when I'm reading a CD (i.e. digital PCM input, digital optical output, what is the DAC doing here) ?

it depends on the signal routing. apparently, cs46xx routes in such a way.

Signature · 2 lines
Takashi Iwai <[email protected]>		SuSE Linux AG - www.suse.de
ALSA Developer				ALSA Project - www.alsa-project.org