Skip to contentSkip to conversation

Box freezes if I enable "AMD 76x native power management"

DISCUSSION Paul Giordano 1 participant 1 message Feb 25, 2003

lore
Share & tools
lore
#0 lore raw

Just another voice in the crowd...

TYAN 2462 dual 1200MP, and another w/ dual 1900MP
Dual WD100 IDE, seperate channels
Current BIOS 2.13
1GB RAM

I noticed this behavior when I started playing with 2.4.20 and could never figger it out - went so far as to bring up KGDB and was way down in the IDE DMA code, scary stuff... Kept scanning LKML and finally found this gem of a thread...

Ran up a clean, fresh kernel from pre4-ac5, four combos
1) CONFIG_AMD_PM768=Y CONFIG_BLK_DEV_IDEDMA_PCI=y
2) CONFIG_AMD_PM768=m CONFIG_BLK_DEV_IDEDMA_PCI=y
3) CONFIG_AMD_PM768=Y CONFIG_BLK_DEV_IDEDMA_PCI is not set
4) CONFIG_AMD_PM768=m CONFIG_BLK_DEV_IDEDMA_PCI is not set

In cases 1 and 3, hang at boot, pressing the power button frees it up. In cases 2 and 4, no boot hang, and, at lease for me, no hang when amd76x_pm module's loaded

So, back to playing - if you need some testing on this board, let me know - I use one at work and one at home, takes no time at all to gen up and try things out, and they'll get pretty good exercise.

Regards,
Gio

Please cc: - not subscribed to LKML