2.5.67-mm2 booting problems!
Ok, this puzzles me a bit -
i just upgraded 2.5.67 to -mm2, and it won't boot it just stalls after
'Booting Linux kernel....' or something similiar - and nothing.
I have CONFIG_VT=y and CONFIG_INPUT=y set, which is why i don't get it - that was the problem with 2.5.67, but i fixed that, and the .config should be intact after patching the kernel, shouldn't it?
Any suggestions ?
Signature · 5 lines
======================================================================== | Mads F. Christensen || email: | | phone: +45 27 47 58 66 || [email protected] | | Webdesign Development || www.krycek.org - personal data site | ========================================================================
Quoted 8 lines · Mads Christensen
Ok, this puzzles me a bit -
i just upgraded 2.5.67 to -mm2, and it won't boot it just stalls after'Booting Linux kernel....' or something similiar - and nothing.
I have
CONFIG_VT=yandCONFIG_INPUT=yset, which is why i don't get it - that was the problem with 2.5.67, but i fixed that, and the .config should be intact after patching the kernel, shouldn't it?
I suggest you to try 2.5.67-mm3 instead. To do so, first revert 2.5.67-mm2 (patch -p1 -R), then apply 2.5.67-mm3 (patch -p1) and then run "make oldconfig" over your current ".config" file.
Signature · 3 lines
Please AVOID sending me WORD, EXCEL or POWERPOINT attachments. See http://www.fsf.org/philosophy/no-word-attachments.html Linux Registered User #287198