Skip to contentSkip to conversation

more or less pcmcia hdsp problems

DISCUSSION jfm3 2 participants 2 messages May 12, 2003

lore
Share & tools
lore

jfm3

author
#0 lore raw

Planet CCRMA: kernel 2.4.20+stuff, alsa 0.9.2

OK. I get further after putting this into the first lines of /etc/rc.sysinit:

modprobe pcmcia_core
modprobe yenta_socket
modprobe ds
modprobe snd-hammerfall-mem

dmesg output:
PCI: Enabling device 01:00.0 (0080 -> 0082)
Hammerfall memory allocator: buffers allocated for 1 cards
PCI: Setting latency timer of device 01:00.0 to 64
ALSA ../../alsa-kernel/pci/rme9652/hdsp.c:508: Hammerfall-DSP: no Digiface or Multiface connected!
ALSA ../../alsa-kernel/pci/rme9652/hdsp.c:4092: card initialization pending : waiting for firmware

edited lspci -vv output:
01:00.0 Multimedia audio controller: Xilinx, Inc. RME Hammerfall DSP (rev 0b)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping+ SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-

        Latency: 64
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at 17800000 (32-bit, non-prefetchable)

[size=64K]

hdsploader output:
hdsploader - firmware loader for RME Hammerfall DSP cards Looking for HDSP + Multiface or Digiface cards :
Card 0 : RME Hammerfall DSP at 0x17800000, irq 9 Upload firmware for card hw:0
<<< good long pause >>>
Hwdep ioctl error on card hw:0 : Input/output error.

Yell at me if this belongs on alsa-user. I honestly can't tell.

Is this one of those "your firmware is too new" problems I've heard so much about?

Signature · 8 lines
(jfm3  2838 BCBA 93BA 3058 ED95  A42C 37DB 66D1 B43C 9FD0)



-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara
The only event dedicated to issues related to Linux enterprise solutions
www.enterpriselinuxforum.com
#1 lore raw
Quoted 8 lines

Upload firmware for card hw:0
<<< good long pause >>>
Hwdep ioctl error on card hw:0 : Input/output error.

Yell at me if this belongs on alsa-user. I honestly can't tell.

Is this one of those "your firmware is too new" problems I've heard so much about?

i don't think so. but alas, i don't have a different answer for you right now. let me think about and get back to you. can you check dmesg for messages when this happens?

-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara The only event dedicated to issues related to Linux enterprise solutions www.enterpriselinuxforum.com