Skip to contentSkip to conversation

alsa & snd-hdsp

DISCUSSION David E. Storey 2 participants 2 messages May 23, 2003 – May 24, 2003

lore
Share & tools
lore
#0 lore raw

ok...

I'd like to know if I fumez le crack! Is there any way to adjust the gain on any HDSP inputs via alsa? I know there exist simple controls, which control the output volume and the mixer controls which handily set the volume between any input and output.... so what about input? The mixer in winbloze seems not to adjust input level either? Is this a firmware issue? Do I need to get an 8-channel pre-amp in order to adjust the signals into my multiface?

d!

Signature · 2 lines
Don't ever take a fence down until you know the reason it was put up.
        - G.K. Chesterton
#1 lore raw

David,

I asked about this early on and I believe that the answer is that you
control the input gain externally. Some kind of mixer or pre-amp is needed.

Jan

Quoted 10 lines · David E. Storey

ok...

I'd like to know if I fumez le crack! Is there any way to adjust the gain on any HDSP inputs via alsa? I know there exist simple controls, which control the output volume and the mixer controls which handily set the volume between any input and output.... so what about input? The mixer in winbloze seems not to adjust input level either? Is this a firmware issue? Do I need to get an 8-channel pre-amp in order to adjust the signals into my multiface?

Quoted 6 lines

d!

Signature · 2 lines
Don't ever take a fence down until you know the reason it was put up.
        - G.K. Chesterton

-------------------------------------------------------
This SF.net email is sponsored by: ObjectStore.
If flattening out C++ or Java code to make your application fit in a relational database is painful, don't do it! Check out ObjectStore. Now part of Progress Software. http://www.objectstore.net/sourceforge