IDE-Controller problems (2.6.0-test2-mm1/2)

Hi all

Since test2-mm1 the kernel will not properly detect or enable my via IDE-Controller. This is what I get:

VP_IDE: IDE controller at PCI slot 0000:00:11.1
VP_IDE: (ide_setup_pci_device:) Could not enable device.

2.6.0-test1-mm1 works though:

VP_IDE: IDE controller at PCI slot 0000:00:11.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci0000:00:11.1

    ide0: BM-DMA at 0xe800-0xe807, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xe808-0xe80f, BIOS settings: hdc:DMA, hdd:DMA

My box is a UP AMD 2700+. Kernel has IO-APIC enabled, but I am passing the noapic kernel option at boot (cause else my USB is screwed up).

Any ideas?

--
Benjamin