Skip to contentSkip to conversation

mass-storage borks on 2.6.0-test9/mm3

DISCUSSION André Ventura Lemos 1 participant 1 message Nov 16, 2003

lore
Share & tools
lore
#0 lore raw

This happens when connecting a Fujifilm FinePix 2400 to the USB port to read the SmartMedia card.

This method works with 2.4.22, but not with 2.6.0-test9 nor 2.6.0-test9-mm3.

Any thoughts?

(please CC me)

messages from the kernel follows:

hub 2-0:1.0: new USB device on port 2, assigned address 4 scsi2 : SCSI emulation for USB Mass Storage devices
Vendor: Fujifilm Model: FinePix 1400Zoom Rev: 1000
Type: Direct-Access ANSI SCSI revision: 02
sda : READ CAPACITY failed.
sda : status=0, message=00, host=7, driver=00
sda : sense not available.
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda : READ CAPACITY failed.
sda : status=0, message=00, host=7, driver=00
sda : sense not available.
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda : READ CAPACITY failed.
sda : status=0, message=00, host=7, driver=00
sda : sense not available.
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
/dev/scsi/host2/bus0/target0/lun0:<3>Buffer I/O error on device sda,
logical block 0
Buffer I/O error on device sda, logical block 0
unable to read partition table /dev/scsi/host2/bus0/target0/lun0:<3>Buffer I/O error on device sda,
logical block 0
unable to read partition table
Attached scsi removable disk sda at scsi2, channel 0, id 0, lun 0 Attached scsi generic sg1 at scsi2, channel 0, id 0, lun 0, type 0
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 4

Signature · 1 line
Lego my ego, and I'll lego your knowledge